Ubislate Torque 3G7 Flash File Tab MT6572 4.4.2 Update Firmware
Ubislate Torque 3G7 Flash File Tab MT6572 4.4.2 Update Firmware
Ubislate Torque 3G7 is a tablet device from Datawind, a company that aims to provide affordable internet access to the masses. The tablet runs on Android 4.4.2 KitKat operating system and has a MediaTek MT6572 chipset with a dual-core processor and 512 MB of RAM. The tablet has a 7-inch display with a resolution of 1024 x 600 pixels and supports 3G connectivity via a SIM card slot.
Like any other Android device, the Ubislate Torque 3G7 can be updated with a new firmware to improve its performance, fix bugs, or add new features. However, updating the firmware can also be risky, as it may cause the device to malfunction, brick, or lose data if not done properly. Therefore, it is important to follow some precautions and steps before updating the firmware of the Ubislate Torque 3G7.
Download Zip: https://tweeat.com/2w4dvO
Precautions and Requirements
Backup your important data such as contacts, messages, photos, videos, etc. to a safe location such as a computer, an external storage device, or a cloud service.
Charge your tablet battery to at least 50% or more to avoid any interruption during the update process.
Download the flash file that contains the firmware for your Ubislate Torque 3G7 from a reliable source. The flash file should have a .zip or .rar extension and should match the model number and chipset of your device.
Download and install a flash tool that can flash the firmware to your device. There are many flash tools available online, but one of the most popular ones is SP Flash Tool, which supports MediaTek devices.
Download and install the USB drivers for your device on your computer. This will ensure that your computer can recognize your device when connected via a USB cable.
Enable USB debugging mode on your device by going to Settings > Developer Options > USB Debugging. If you don't see Developer Options in your settings menu, you can enable it by tapping on Build Number seven times in Settings > About Tablet.
Steps to Update Firmware
Extract the flash file that you downloaded to a folder on your computer. You should see a scatter file with a .txt extension and some other files with .bin or .img extensions.
Launch SP Flash Tool on your computer and click on Scatter-loading button. Browse to the folder where you extracted the flash file and select the scatter file.
The flash tool will load the firmware files and show them in a table. Make sure all the files are checked and their locations are correct.
Click on Download button at the top of the flash tool. This will start the flashing process.
Turn off your tablet and connect it to your computer via a USB cable. The flash tool will detect your device and start flashing the firmware.
Wait for the flashing process to complete. You will see a green circle with a check mark when it is done.
Disconnect your tablet from your computer and turn it on. It may take some time for the first boot, so be patient.
Congratulations! You have successfully updated the firmware of your Ubislate Torque 3G7 tablet.
Sources
The information in this article was obtained from the following sources:
[Dr Indira Naidoo Institute]
[Blended Broads]
[Nostalgic Saha]